Services

RIVER SAND

River sand is procured from river streams & banks. This type of sand has rounded grains generally in white-grey colour. River sand has many uses in the construction purpose must be clean, free from waste stones & impurities. It is important to know what type of sand is beneficial for construction purpose as sand is also classified into three different forms that make it suitable for specific type of construction.

AGGREGATE / BLUE METALS

Construction aggregate, or simply “aggregate“, is a broad category of coarse particulate material used in construction, includings and, gravel, crushed stone, slag, recycled concrete & geosynthetic aggregates. Aggregates are the most mined materials in the world. Aggregates are a component of composite materials such as concrete & asphalt concrete; the aggregate serves as reinforcement to add strength to the overall composite material. Due to the relatively high hydraulic conductivity value as compared to most soils, aggregates are widely used in drainage applications such as foundation and French drains, septic drain fields, retaining wall drains & Road side edge drains.

CONCRETE BLOCKS

Concrete is generally defined as an aggregate of cement with sand & gravel or with sand & curshed rock, or simply with crushed stone & the crusher dust & screening from same, mixed with the proper proporation of water to make a material which can be molded into any desired shape while in plastic or semi plastic state or only sufficiently damp to pack solid when tamped & which will “Set” in this molded shape without deformation making an artifical stone.

Solid & hollow concrete blocks are manufactured in factories to meet the requirements of building blocks in cities and towns. These blocks may be called as artificial stones, since they replace the stones in the masonry construction. They are manufactured with lean mixes of cement, sand and aggregates of sizes less than 12 mm. Instead of sharp edged aggregates, round aggregates are professed in the manufacture of these blocks.

Both solid & hollow blocks can be used for the construction of load bearing as well as partition walls. They are ideally suited for the construction of compound walls.

BRICKS

Bricks are essential raw material required in every construction but which type of brick should be used in specific type of construction is important to know. Bricks vary in type, size and shape that are used in masonry purpose. Actual bricks that are used for construction must be properly dried and treated for better durability. Bricks are said to be completely burnt when they make hard sound on being clasped together. Good bricks are characteristics with good & uniform shape, correct rectangular shape and hard edges.

AAC BLOCK

Autoclaved aerated concrete is a versatile lightweight construction material and usually used as blocks. Compared with normal (ie: “dense” concrete) aircrete has a low density and excellent insulation properties.

The low density is achieved by the formation of air voids to produce a cellular structure. These voids are typically 1mm – 5mm across and give the material its characteristic appearance. Blocks typically have strengths ranging from 3-9 Nmm-2 (when tested in accordance with BS EN 771-1:2000). Densities range from about 460 to 750 kg m-3; for comparison, medium density concrete blocks have a typical density range of 1350-1500 kg m-3 and dense concrete blocks a range of 2300-2500 kg m-3.

TMT BAR

FE-500/D TMT BAR

Thermo mechanically treated steel, known as TMT steel, can be described as a new-generation-high-strength steel having superior properties such as weld-ability, strength, ductility and bend-ability meeting highest quality standards of international level. RE-BARS is manufactured from superior quality billets manufactured in the same plant according to the requirement of the customers. RE-BARS of FE-500 grade for sizes ranging between 8mm to 40mm. The standard length of the bar is 12mtrs.

STRUCTURAL STEEL

Structural steel (Angle, Beam, Channel, Plate, Flat, etc.,) is a category of steel used for making construction materials in a variety of shapes. Many structural steel shapes take the form of an elongated beam having a profile of a specific cross section. Structural steel shapes, sizes, chemical composition, mechanical properties such as strengths, storage practices, etc.

EXPORT

TO REACH YOUR EXPECTATIONS.

TO KEEPING YOUR PROJECT IN TRACK

WE MAKE YOUR DREAMS COME TRUE,CHANGE START FROM HERE

WE SRI GANAPATHY ENTERPRISES SUPPLYING

AGGREGATES, BOLDERS IN ALL DIMENSIONS AND RIVER SAND

TO THE EXPORTERS AT CHENNAI PORT ,NOW EXPORTING

DIRECTLY TO THE VALUED CUSTOMERS IN BANGALADESH,

MEYYANMAR, SRILANKA AND MALDIVES.

We have EXCELLENT team of professionals, which supports us in all the activities of trade. Our procurement is inspected by quality team, on certain parameters so as to ensure their quality .Our logistics team assures that the consignments are delivered in time to the customers’ destination. In this regards we have earned valuable & good client.

We are the market leaderses we are in association with reputed miners to procure the offered range. The Mines and Crushers with whom we have associated have the finest quality material in the manufacturing process of aggregates and allied material with international quality standards.